So did you just trim the other inter plane strut? I guess could try and peel back the covering and trim it

loctited the crews some were not even in all they way.

Quote Originally Posted by Cosmith View Post
I had the same sorts of issues. Exact same interplane strut fit issue. I had a feeling the canopy latch was inadequate and mine let go after about half a dozen flights. I'm still using pliers on all but one of the strut pins, and that one requires tape to stay in. I personally wasn't impressed with some of the hardware and there were problems with my rudder hinging. If I did it over again I would glue the strut blocks into the wings with the plane fully assembled. I did a test for and it seemed fine but after I glued it I ran into the same issue you have... seems like just the one block goes to deep into the wing.

I have to say though, once I flew it I forget about the little flaws. The airframe is amazing to fly, your going to love it.

****Make sure you loctite the servo arm screws and check them frequently. The arms are a very sloppy fit on the spline and like to loosen. Did you flip the servo mounting grommet inserts?