129" Pilot-RC Yak54 / MOKI-257... A Little Remodel

[hitechflyer]

I didn't really study those rims, but they might be two half's screwed together.
(Clam shells)
Beware if u modifie

[tbrum]

I didn't really study those rims, but they might be two halls screwed together.
(Clam shells)
Beware if u modifie

They are Hank... each clamshell sandwiches a flange of the rubber tire and clamped together with (6) 4-40 SHCS. Exact same concept as Bohetec wheels on the jets.

[tbrum]

Sounds like some may not be following the Moki engine thread on Canucks since I've been asked if I ran the Moki this weekend, so I'll post this video here also!

I almost pee'd my pants in excitement when it lit up, LOL

[hitechflyer]

Awesome Trev, watch that shovel doesn't get airborne

[Terryscustom]

200% Awesome right there...

[tbrum]

Ya.. this is going to be a fun plane!! I wasn't able to try the smoke because my smoke fluid was too thick to pump, LOL.

When the weather warms up a bit, I'll paint the hatch, cowl and gear. Just not in the mood for painting in -15C

[akabek]

Hey Trevor, since you are running smoke did you seal the firewall area with epoxy?

[Dan Crash O]

Ya.. this is going to be a fun plane!! I wasn't able to try the smoke because my smoke fluid was too thick to pump, LOL.

When the weather warms up a bit, I'll paint the hatch, cowl and gear. Just not in the mood for painting in -15C

ThAt happened to me and lorne the other day too lol I was so excited ..... And nothing

[tbrum]

Hey Trevor, since you are running smoke did you seal the firewall area with epoxy?

Yep, I will eventually! And I will seal off the tunnel opening, LOL.

ThAt happened to me and lorne the other day too lol I was so excited ..... And nothing

Ya... all that pent up excitement to smoke out the neighbours and you can't even pump it out of the can, LOL.

[akabek]

By the way is there a "preferred" smoke oil I should consider?