0
![Not allowed!](images/buttons/up_dis.png)
Thumbs Up |
Received: 49 Given: 32 |
I just weighed the heaviest panel. Only 217 grams.
Thumbs Up |
Received: 49 Given: 32 |
Off for the week.. Hope to get TONS DONE!!!!!!!!!!!!!!
Made the wing tube receiver from 2 wraps of 4oz
Started roughing out the wing forms with cardboard. I will transfer them to paper. Im very lucky that my neighbor told me he bought a laser cutter last fall.. He's got some business coming his way![]()
Thumbs Up |
Received: 49 Given: 32 |
I guess I wont need to be selling the FPV attachment for the WETJET anymore![]()
Last edited by Vettster; 03-21-2017 at 09:16 AM.
Thumbs Up |
Received: 33 Given: 2 |
Your pic is too small to see anything. If you build it someone will buy it....whether it makes common sense or not. LOL
Thumbs Up |
Received: 49 Given: 32 |
fixed....
Last edited by Vettster; 03-21-2017 at 09:16 AM.
Thumbs Up |
Received: 49 Given: 32 |
Paper traces transferred to partial board. Now I can sand down to properly fit when mold is closed. After that they will be traced onto paper again and sent off to be laser cut.
Thumbs Up |
Received: 49 Given: 32 |
So! How will I know where the high and low spots are on the formers to be sanded or added to? Add balls of putty Place small pieces of wax paper on top so it doesn't stick and bango! its that easy. I actually was very lucky.. Just the slightest sanding near the tip and I have to add about 2mm at the rear. Very easy. Once I correct them, I will then transfer to paper for the laser. I will have about 4 sets made.
Thumbs Up |
Received: 49 Given: 32 |
Decided to have Andy help me out with the laser cutting.
Last edited by Vettster; 04-06-2017 at 02:13 PM.
Thumbs Up |
Received: 33 Given: 2 |
Andy does a great job. Looking forward to more progress here.
Thumbs Up |
Received: 49 Given: 32 |
Time to lay down some serious cloth.
I two sided tape the hatches down.
There are currently 14 users browsing this thread. (0 members and 14 guests)