0
![Not allowed!](images/buttons/up_dis.png)
Thumbs Up |
Received: 114 Given: 14 |
Jack,
It's used i bought it from out west again so it's not doing a U Turn and heading back. It's going in a 35% Carden 300/330 that I'm presently recovering, http://rccanucks.com/showthread.php?...-35-Carden-330
Tunnels in this not long enough for pipes so going with Cans. Don't have any Hype Cans do ya? LOL
J
Thumbs Up |
Received: 56 Given: 58 |
Be careful Jim. When I bought that airframe I thought I could use some generic cans I had but found the tunnel too short and then found Dave built it to use the MTW K series cans with larger diameter and shorter length. So I bought them from DA. You might have to rebuild the tunnel for any other cans.
Humber Valley RC Flyers
Thumbs Up |
Received: 114 Given: 14 |
Paul,
Thanks for the tip.
I just ook a look at some cans I mocked in but they may be to close to the engine. Heck I think they might even be Hype Cans. I can't remember half the stuff I buy. LOL
I'll have to check and make sure before I go to Toledo as I might have to pick up some of those K Series cans. I've used them before. They wer in my Carden9 on a 3W55, well one can only. LOL
Thumbs Up |
Received: 114 Given: 14 |
Denis,
Those are inferior MTW RE2s.
I just remembered I bought some of Lorne's Hype Pipes, brand new of a good Northern Friend on that other site and already have some Blane Bender front dump cans in the Carden which should work. Although this might be along the lines of the original post Hype or Bender?
There are currently 2 users browsing this thread. (0 members and 2 guests)