Hype or Bender

[JDaly]

LOL.....send the redheads west. No water close by. Is the 110CS new Jim?

Brodie...ya Manny took them, had GP headers on them as well.

Jack,

It's used i bought it from out west again so it's not doing a U Turn and heading back. It's going in a 35% Carden 300/330 that I'm presently recovering, http://rccanucks.com/showthread.php?...-35-Carden-330

Tunnels in this not long enough for pipes so going with Cans. Don't have any Hype Cans do ya? LOL

J

[rpm]

Jack,

It's used i bought it from out west again so it's not doing a U Turn and heading back. It's going in a 35% Carden 300/330 that I'm presently recovering, http://rccanucks.com/showthread.php?...-35-Carden-330

Tunnels in this not long enough for pipes so going with Cans. Don't have any Hype Cans do ya? LOL

J

Be careful Jim. When I bought that airframe I thought I could use some generic cans I had but found the tunnel too short and then found Dave built it to use the MTW K series cans with larger diameter and shorter length. So I bought them from DA. You might have to rebuild the tunnel for any other cans.

[JDaly]

Be careful Jim. When I bought that airframe I thought I could use some generic cans I had but found the tunnel too short and then found Dave built it to use the MTW K series cans with larger diameter and shorter length. So I bought them from DA. You might have to rebuild the tunnel for any other cans.

Paul,

Thanks for the tip.

I just ook a look at some cans I mocked in but they may be to close to the engine. Heck I think they might even be Hype Cans. I can't remember half the stuff I buy. LOL

I'll have to check and make sure before I go to Toledo as I might have to pick up some of those K Series cans. I've used them before. They wer in my Carden9 on a 3W55, well one can only. LOL

[Bhughes]

LOL.....send the redheads west. No water close by. Is the 110CS new Jim?

Brodie...ya Manny took them, had GP headers on them as well.

They’ve been tainted then. No good any more jack.

[wingburner]

They’ve been tainted then. No good any more jack.

Exactly!!!

[JDaly]

they’ve been tainted then. No good any more jack.

Oh The Horror!

[wingburner]

Oh The Horror!

Can't believe that company is still in business!

[Dennis P]

so Jack did you ever get the DA120 and put it in something or are those Hype Pipes just sitting there collecting dust and available for my DA120?

Trumpetman has a set for sale on the other Canadian RC site

[JDaly]

Trumpetman has a set for sale on the other Canadian RC site

Denis,

Those are inferior MTW RE2s.

I just remembered I bought some of Lorne's Hype Pipes, brand new of a good Northern Friend on that other site and already have some Blane Bender front dump cans in the Carden which should work. Although this might be along the lines of the original post Hype or Bender?