Atomizing Smoke Oil Injection Nozzles, header no-weld kits, & turbine smoke tubes

[crankcase]

PM sent.

Rick, your order is shipping today.
For some reason the feedback page is not liking the thread URL. "Invalid URL" message is what I get when I copy and paste the URL header.
If you require a feedback rating let me know and I can get a moderator involved.

Thank you for your order!

[-Rick-]

Rick, your order is shipping today.
For some reason the feedback page is not liking the thread URL. "Invalid URL" message is what I get when I copy and paste the URL header.
If you require a feedback rating let me know and I can get a moderator involved.

Thank you for your order!

All good Harlan, not to worried about feed back. Thanks for getting it shipped so fast!

[PaulD]

Do you have any video links to these nozzles working in aircraft - preferably Jets.

PaulD

[crankcase]

I'm personally not a turbine flyer myself but here is a customer video of a ground test with a P60 and 1 standard orifice nozzle.
https://youtu.be/_TaZ_oiVfwg

And a post with pic showing twin standard orifice nozzles on a 220 turbine.
https://www.flyinggiants.com/forums/...&postcount=200

NASA 60% cub turboprop
https://youtu.be/-9u9POhZXlw

Brian Strachan XFC 2016 GP123 on std mufflers. Twin smoke nozzles.
https://youtu.be/l2pqHXWScHU

John Craven GP176 on canisters. Twin smoke nozzles & no-weld kits w/ twin 2.5' preheater coils.
https://youtu.be/b-YVfKYCb44

[PaulD]

Thanks, how much total for two nozzles posted to Coquitlam, BC, V3C5L6,

Paul

[crankcase]

Thanks, how much total for two nozzles posted to Coquitlam, BC, V3C5L6,

Paul

Nozzles $20 ea
Flat rate shipping to Canada $11 for the order.

$51 Total shipped.
Shipping is via USPS and customs barcode tracking number communicated at time of shipment.

[Heligaz]

Got my order from Harlan

Shipping was fast
The smoke nipples look amazing
I have removed the cowl and will remove mufflers and install them hopefully by the weekend
Got to get the angle correct . Will use these on a GP123 with stock mufflers

Thanks Harlan

[-Rick-]

Received my order today, fast shipping!

Going into a EF Yak 88 inch with a EME 60cc on a can. Looking forwards to my first smoke system!

Thanks Harlan!

[crankcase]

So I wanted to do a side by side comparison of Atomizing Smoke Oil Injection Nozzles vs Bison smoke injector fittings showing the finish and function of each. Shown below is what you get in both setups, and then close ups of the line-up: SST Bad Dog, Ti Bad Dog, Brass Bisson.
Bisson fittings are brass and use 8/32 tap size.
Bad Dog nozzles use a 10/32 tap size and are offered in Stainless Steel or Titanium at the same price.

In the last photo I adapted a garden hose to a tee fitting and ran for approximately 45 seconds and captured the dispensed fluid. I would have overflowed the Bisson breaker running for a full minute.

[-Rick-]

Installing the smoke nozzle was the easiest part of putting in this smoke system. I made the tray for all the smoke equipment so that it is easy to remove.

Almost zero residue on the plane after two flights with it on most of the time.

Thanks for the great nozzle Harlan!!