CPLR Hui Yang SupraSkybolt Pattern Plane / YS200

[tbrum]

Nope. Definitely not typical!

Learning a lot about pattern ship setup!!

[tbrum]

Here is the tuned pipe install. I made the 1/16” lite ply backing plate also the ignition mount.

Still cooling holes to cut in the lower cheek cowl to keep the YS200 cool

[tbrum]

Throttle servo installed with Sullivan Gold N Rod and metal clevis.

BLS173

[tbrum]

Got tank plumbed up and installed. Used loop-side of Velcro around formers to cushion the tank.

Equipment mounting plate installed and formers that secure the tank!

I’m paranoid about a silicon line coming off, so twist wrapped all fittings with SS wire

Battery is a LiIon 2S-2800mAh

Switch is a Powerbox DigiSwitch, mounted from inside

[tbrum]

So this plane will be running Futaba SBUS. I made up a 2-piece wiring harness with Powerbox wire and servo ends.

Nice and light this way!

[tbrum]

Internal wiring, iBEC, PB switch, LiIon battery....

[tbrum]

And final pics!!!

CG came out perfect at 130mm behind lower wing LE

Well under the 5kg weight limit !!!!

[tbrum]

Looks like we have to leave the maiden of this until the spring!!!

In the meantime it’s ready to go back to Peter all dressed up!!!

[thaley]

love it. love the ys 200, I had a ys120 supercharged once, awsome little beast. love the exhaust on this beauty, and you were able to shoot it down to keep all that slippery slimmy glo snot off the plane, good job on this one Trevor.