What's your winter project this year?

[habs992000]

.....Sig Somethin Extra....

[itizme]

After building five Clik Ng's I have two Edge 540's to build. Then it's vacation time towards the end of November for a few weeks.

[BMS]

Putting the belly back in to a old .25 Falcon, set her up with electric propulsion. Will test and install FPV gear if behaves in the air.....

[Sour kraut]

My winter project showed at my door this afternoon...a SSE. Going to get through the Christmas holidays and start to tackle it.

.....Sig Somethin Extra....

Have a blast with the SSE build Dan...you will enjoy it immensley ...

Regards
Curt

[Balsa Cat]

Dear BMS!

I see you have a nice Sbach, I would like to buy one next week. But not big just whit 1850mm wingspam...
Intresting for me, you have a good or wrong experiences...
This is my first 3D model, before I was flying just F3A model, this is a new category for me! Many people said, this is a good and easy starter plane, this is true?

[BMS]

I am on my third one, The first 30cc didn't fly great, but I was lacking experience. The next one was a 50cc Goldwing, and it flew a lot better than the 30cc. The 100cc one flies like a kite. I intended on using it as a IMAC plane, just didn't get to any comps this year. My telemetry tells me it will take off as slow as 6mph, and doesn't display any issues in ordinary type flying. I don't fly 3D, might try it at some point.

[Balsa Cat]

Thank you, this is important information for me Thank you BMS

[akabek]

Once I get a couple of ARFs and my TH indoor YAK done I will be attempting my first short kit build. I wanted to build a compact pattern plane with a nitro engine and tuned pipe. I found a kit sold by a kit builder in Quebec for a Mach 8 which is the 40 size of a Mach 1. I am looking forward to it.

[Dave Asquini]

I'm putting together a 38% Team Edge ( Bill Hempl ) Super Decathlon with a EME 120

[BAMDFISHER]

I'm putting together a 38% Team Edge ( Bill Hempl ) Super Decathlon with a EME 120

Dave for my big Decathlon with the same EME 120 engine, I had Lance at Bisson Mufflers build me a custom set that had extended pipes so as to clear the bottom of the cowl, added baffling for more noise reduction and he modified them so that I could easily tune the engine. He added special guide tubes that allowed my screwdriver to reach the High and Low needles. If interested let me know and I will get more details.

Brian