BVM Bandit / BF100

[tbrum]

Really tight inside this little beast so following some of the instructions for equipment install.

Pump and valves mounted to a plate down in the equipment area

ProJet ECU is massive so going back there also

[tbrum]

Steering servo (9411) mounted on the middle equipment tray

[tbrum]

I made up an upper equipment plate with an angled bridge to hold the Tams UAT

2 x Jettronics double valves - gear and doors
1 x UP1 - brakes
Jeti REX10
Powerbox Pioneer
2S-2500 LiFe for Rx
3S-2500 LiPo for turbine
ProJet telem

[tbrum]

I installed the clear canopy with lotsa magnets and canopy glue

Once cured, I sealed the glue joint on the inside with Hysol.

[tbrum]

Here’s the weight and CG check. Came out bang on - no lead required